Why do trucks leave half empty?
- Planning in silos. Each site, business unit or customer team books its own transport, so nobody sees the freight that could travel together.
- Late visibility of demand. Orders reach transport planning too late to be combined before the cut-off.
- Order-driven loading. Loads are built around individual orders instead of destinations and routes.
- Rigid carrier set-ups. Fixed lanes and dedicated vehicles run on schedule whether they are full or not.
- No feedback loop. Fill rates are rarely measured per lane, so the empty space stays invisible.
What does it cost?
A truck costs almost the same to run whether it is full or half full, so every empty pallet space raises the cost per unit shipped. The same applies to emissions: fewer units share each journey’s fuel, so emissions per unit rise too.
As transport emissions move into Scope 3 reporting under rules such as the EU’s CSRD, low fill rates show up in sustainability reports as well as in the freight bill.
How do you raise truck fill rates?
- Measure fill rate per lane. Start with the lanes where the gap between capacity and use is largest.
- Pool demand across sites. Bring orders from all sites and customers into one planning view before they are booked.
- Consolidate at a hub. Use a cross-dock or pool point to combine part-loads into full outbound trucks.
- Plan by destination. Build loads around routes and regions, with a maximum holding time so service is protected.
- Choose the right service per load. Match each load to the most cost-effective option: dedicated, consolidated, multi-stop or multimodal.
How MIXMOVE helps
MIXMOVE connects transport demand, carrier capacity and execution across sites, so planners can see what needs to move before it is booked. It replaces multiple part-shipments with fewer, fuller loads and selects the most cost-effective service for each destination, across road, sea and air.
3M EMEA reached a 90% truck fill rate and reduced transport costs by 35% and line-haul CO₂ emissions by 50% with MIXMOVE. MIXMOVE works alongside an existing TMS, WMS and ERP as an orchestration layer, or as a standalone platform.
Frequently asked questions
What is a good truck fill rate?
It depends on the freight and the network. Planners usually track the trend per lane rather than one target, and look first at the lanes running furthest below capacity.
Does consolidating loads delay deliveries?
Not if it is planned well. A maximum holding time per order keeps consolidation inside the delivery promise.
Is fill rate measured by weight or volume?
Both are used. Light, bulky goods fill space before weight, while dense goods hit weight limits first, so many teams track loading metres or pallet spaces as well.